ecozone editura ecozone iasi

» Autentificare

E-mail:
Parola:
   
  Cont nou
Va rugam sa va autentificati pentru a putea comanda carti

» Cautare

  » Ultimele cautari

Rezultatele pentru roughness

Rezultate gasite: 13

Ecological polymer used for macro-defect-free cements (MDF) production
Environmental Engineering and Management Journal › Vol. 8 › Nr. 4
Abstract Macro-Defect-Free (MDF) cements are polymer-cement composites characterized by high value of flexural strength. Due to their thermal and electrical insulating properties, MDF cements could replace other insulators obtained by environmental non-friendlier technologies or being themselves toxic and non-biodegradable. MDF cements obtained by the use of an ecologic polymer (poly(vinyl alcohol)) shows high mechanical resistance in the initial state but also it’s dramatic decrease after ...
Autori: , Georgeta Moise, Hulusi Ozkul, Ozgur Ekincioglu, Catalin Croitoru
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=25493

Photocatalytic properties of titania - fly ash thin films
Environmental Engineering and Management Journal › Vol. 8 › Nr. 4
Abstract The paper presents the results obtained when using thin films (doctor blade) of titanium oxide powder (Degussa P25) and fly ashactivated with NaOH, for advanced treatment of complex waters resulted in the textile industry. There are studied the heavy metal(cadmium, copper) adsorption and the dyes (methyl orange and methylene blue) photo-degradation using these novel substrates.The thin films crystallinity (XRD), morphology and roughness (AFM) were evaluated and no significant changes...
Autori: Anca Duta, Luminita Andronic, Maria Visa
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=25500

ON THE INFLUENCE OF BED FORMS ON FLOOD LEVELS
Environmental Engineering and Management Journal › Vol. 12 › Nr. 5
AbstractFlood inundation modelling and flood risk mapping are primary cornerstones of flood risk assessment and management.Modelling activities generally assume that the morphology of the conveyance does not change, which certainly is not true foralluvial rivers. River bed elevations can quickly change during flood events. Flood water can induce different bed-forms (ripples,dunes, plain bed, etc.), which affects the flow resistance and as a result the flood water level. As a result integrating t...
Autori: Biswa Bhattacharya, Ioana Popescu, MdShamim Shams
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=26016

TECHNICAL SOLUTION TO REDUCE SOIL EROSION PRODUCED BY TAZLAU RIVER IN TARATA PERIMETER, ROMANIA
Environmental Engineering and Management Journal › Vol. 13 › Nr. 8
AbstractThe paper analyses the hydrologic parameters of the Tarata perimeter with alluvial soils, in order to estimate the values of theTazlau River behaviour, in case of flooding. Tazlau River flow rate has an annual average value of 4.9 m³/s, with a torrentialcharacter when the level of precipitation is increasing. The analysis of this perimeter is of interest today as a result of the existingexcessive erosion. We identified a possible solution to reduce soil erosion through the exploitation o...
Autori: Stelian Cartacuzencu
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=26469

RESEARCH AND TRENDS IN PRODUCT LIFE CYCLE MANAGEMENT IN THE CONTEXT OF SUSTAINABLE DEVELOPMENT
Environmental Engineering and Management Journal › Vol. 14 › Nr. 1
Abstract During the creation of a product, the majority of the enterprises still apply a linear approach. This approach has been imposed by the organization way of the company and by the informational flow between the different departments. In the present time different models of integrated engineering oppose to the sequential organization. These models permit the simultaneity of the activities deploying or at least their partial overlap. The activities overlap can be imagined eliminating fi...
Autori: Petrică Corăbieru
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=26633

MICROBIAL SAFETY OF PLASTIC MATERIALS OBTAINED FROM WASTES
Environmental Engineering and Management Journal › Vol. 14 › Nr. 6
Abstract Extensive use of plastics leads to the increase of non biodegradable wastes that have to be recycled due to both dramatically decrease of natural resources to producing them and to their increasing need as well as due to environmental issues. Most of goods made by materials based on wastes have to be commonly used by people. Antibacterial character of those is necessary to avoid epidemics. This paper deals with determination of antimicrobial character of materials based on polymeric...
Autori: Florica Silvia Cristina Patachia
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=26751

STUDY OF PRESSURE DROP IN FIXED, FLUIDIZED AND SPOUTED BED OF SEVERAL ADSORBENT MATERIALS
Environmental Engineering and Management Journal › Vol. 14 › Nr. 10
Abstract An experimental study on the hydrodynamics of fixed, fluidized and spouted granular bed was performed. With this aim two commercial adsorbent materials and a composite material obtained by impregnation with a hygroscopic inorganic salt were employed. The fluid phase consisted in dry air. The obtained results highlight the influence of grain size, material density and roughness over pressure drop and gas velocity. Increasing grain size leads to decreasing pressure drop and increasing...
Autori: Ioan Solomon
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=26854

DERIVING THE FLOODPLAIN IN RURAL AREAS FOR HIGH EXCEEDANCE PROBABILITY HAVING LIMITED DATA SOURCE
Environmental Engineering and Management Journal › Vol. 15 › Nr. 8
Hydraulic modelling makes possible the identification of floodplain areas for flash floods with discharge of different return periods. High resolution DEMs allow river bed geometry identification, while prior hydrologic modeling results can serve as input data for the hydraulic model. Once the river bed and floodplain roughness coefficient are set, the floodplains can be delineated on the base of MIKE11 model. For the present study the authors have used three gauged small rivers situated in t...
Autori: Maria-Mihaela Győri
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=27115

A STUDY ON THE MECHANICAL PROPERTIES OF SOME GREEN-COMPOSITES
Environmental Engineering and Management Journal › Vol. 17 › Nr. 12
In this paper, we determined some mechanical properties of a new category of green composites, based on tensile tests. More precisely, we selected a set of samples from a new bio-resin based on Dammar and two sets of samples from green-composites with matrix by bio-resin and reinforced with almost compact layers of Typha latifolia or Schoenoplectus lacustris. For these built materials, we obtained the characteristic curve, tensile strength, percentage elongation after fracture and elasticity mod...
Autori: Ion Ciucă
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=27980

WIND-ERODED NITROGEN BALANCE IN AN ENTIC HAPLUSTOLL UNDER DIFFERENT TILLAGE CONDITIONS
Environmental Engineering and Management Journal › Vol. 18 › Nr. 12
Little information is available on the combined effect of weather conditions and tillage systems on nitrogen lost from wind erosion. A field study was carried out on an Entic Haplustoll to analyze N content in the eroded material. Field measurements were made during the winter fallow (WF) and summer fallow (SF) periods in conventional (CT) and a no-till (NT) fields. Winters are more humid and less windy than summers. Results showed that there were N losses and gains by the wind with both tillage...
Autori: Sergio Alberto Abascal
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=28119

REMOVAL OF METHYL ORANGE AND CADMIUM FROM SOLUTION USING MODIFIED ACTIVATED CHARCOAL
Environmental Engineering and Management Journal › Vol. 19 › Nr. 2
In this work, the removal of methyl orange (MO) and Cd2+ by simultaneous adsorption on adsorbent obtained from modified charcoal (BCBH) coated with TiO2 has been studied. The synthesized materials obtained from wood branches were characterized using atomic force microscopy (AFM) for the roughness and SEM to determine the morphology of the surface. EDX spectroscopy indicates the presence of C, N, O, Na, K, P and Ti on the surface of the adsorbent materials. The micro-porosity and BET specific sur...
Autori: Nicoleta Popa
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=28157

AGRI-WASTES AS A LOW-COST ADSORBENT FOR NICOSULFURON HERBICIDE
Environmental Engineering and Management Journal › Vol. 19 › Nr. 2
The contamination of aquatic and terrestrial environments by pesticides is highlighted by their possible toxic properties and poor biodegradability on the environment. The development of low cost by products from agricultural sectors as a suitable solution for contaminated areas remediation is of great environmental interest. Straw wastes can be considered as a promising alternative to remove different chemical compound that are environmentally toxic. In this study, some materials derived from ...
Autori: Irina Gabriela Cara
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=28161

EFFICIENCY INDICATOR FOR ASSESSMENT OF WATER DISTRIBUTION NETWORKS CARRYING CAPACITY
Environmental Engineering and Management Journal › Vol. 19 › Nr. 5
A water distribution network’s (WDN’s) flow capacity decreases over time mainly because of the unplanned demand growth at its consumption points, increased water loss, and increased internal roughness caused by aging of pipes. In this context, this work presents a new performance indicator, the Carrying Capacity Indicator (ICC). It will enable utility managers to evaluate WDNs’ hydraulic and energy efficiency. The ICC was applied in a real case study: a sector of the Joã...
Autori: Heber Pimentel Gomes
ISSN: 1843 - 3707
http://www.ecozone.ro/reviste.php?RID=28200

Sus

Acasa · Carti editate · Reviste · Despre editura · Abonament · Contact · Cos cumparaturi · Cum platesc? · Termeni si conditii
VisaMaster CardPayU

2001 - 2026 © Copyright Editura EcoZone Iasi Toate drepturile sunt rezervate.
Gazduire skaleweb.ro

SkaleWeb